Entering The Bar Code - Dentsply Sirona Cerec MC Ergänzung Zur Gebrauchsanweisung

5 Entering the bar code

Dentsply Sirona
Supplement to the Operating Instructions, Barcode Reader
5
Entering the bar code
Scanner active, Barcode Reader not active
If you have activated the option "Scanner" in the system configuration
dialog and the option "Barcode Reader" is not active, the bar code will
automatically be read by the scanner. You will be able to enter the
substitute code (8-digit character string, e.g. *1234XYZ) manually on
the PC only if this process fails.
Barcode Reader active
If you have activated the option "Barcode Reader" in the system
configuration dialog, you must read-in both bar codes with the bar code
reader. To do this, hold the bar code reader tilted to a slight angle and
move it over both of the bar codes on the block continuously and
evenly.
If the reading process fails, you can read-in the bar code once again by
pressing "Retry" (button 1 on the unit display). Alternatively, you also
can enter the substitute code (8-digit character string, e.g. *1234XYZ)
on the PC manually.
Scanner not active, Barcode Reader not active
If neither the option "Barcode Reader" nor the scanner has been
activated in the system configuration dialog, you always will be
prompted to enter the substitute code (8-digit character string, e.g.
*1234XYZ) on the PC manually.
No barcode reader present
➢ Enter the replacement code (8-character string, e.g. *1234XYZ)
manually on the PC.
63 22 346 D3439
10
D3439.201.05.04.02 04.2019