Dentsply Sirona Cerec MC Ergänzung Zur Gebrauchsanweisung Seite 19

Dentsply Sirona
Supplement to the Operating Instructions, Barcode Reader
63 22 346 D3439
D3439.201.05.04.02 04.2019
1. Degrease an appropriate surface on the milling unit e.g. on the right
side. Avoid the cross-hatched areas!
2. As a positioning aid, peel the protective paper off the loop strip of
the Velcro tape provided and press it onto the selected area.
IMPORTANT! Roughen the loop strip with a blunt object (e.g. the
back of a spoon).
3. Now press the tool holder onto the loop strip on the milling unit.
4. Insert the block clamp tool on the left and the bar code reader on
the right.
5. If you want to turn the tool holder, take the tools out again, remove
the holder, turn and reposition it.
6. NOTE! Be sure to screw it onto a non cross-hatched area only.
After final positioning, attach the tool holder plate using the 2
screws provided (A).
2 Connecting the barcode reader
5