Dentsply Sirona Cerec MC Ergänzung Zur Gebrauchsanweisung Seite 23

Dentsply Sirona
Supplement to the Operating Instructions, Barcode Reader
63 22 346 D3439
D3439.201.05.04.02 04.2019
CAUTION
Do not use defective milling or grinding results!
Machining results must be judged by the user (dentist or dental
technician) and must not be used if defects are detected!
NOTE
Chips gathered in the grinding chamber
When milling plastic, a large number of chips collect in the grinding
chamber.
➢ After each milling process, remove the chips from the grinding
chamber by hand.
➢ Before removing them, squeeze the chips so that any stored
water is released into the cooling circuit.
NOTE
If you have not used the milling unit for a rather long time, we
recommend you should switch it off and then open the milling
chamber door so that the milling chamber can dry out.
4 Starting the milling process
9