Klein Tools CL900E Gebrauchsanleitung Seite 11

AC/DC VOLTAGE (LESS THAN 1,000 V)
1. Insert the RED test lead into VΩ jack
into the COM jack
to the AC voltage V
2
DC icon on the LCD indicates which setting has been selected.
Black lead Red lead
2. Apply test leads to the circuit to be tested to measure the
voltage. The meter will auto-range to display the measurement
in the most appropriate range.
NOTE: If '–' appears on the LCD, the test leads are being applied
to the circuit in reverse. Change the position of the leads to correct
this.
NOTE: When in a voltage setting and the test leads are open,
readings of the order mV may appear on the display. This is noise
and is normal. By touching the test leads together to close the
circuit, the meter will measure zero volts.
Do not attempt to measure voltages greater than 1,000 V
in any Voltage setting.
AC/DC LoZ VOLTAGE (LESS THAN 600 V)
1. Insert the RED test lead into the VΩ jack
test lead into the COM jack
switch to the AC/DC LoZ voltage
2
defaults to AC measurement. To measure DC, press the 'SEL/DC
ZERO' button
or DC icon on the LCD indicates which mode has been selected.
Note 'AC' or 'DC' on the display.
Black lead Red lead
2. Apply test leads to the circuit to be tested to measure the
voltage. The meter will auto-range to display the measurement
in the most appropriate range.
Do not attempt to measure voltages greater than 600 V
in the LoZ setting.
OPERATING INSTRUCTIONS
, and rotate the Function selector switch
4
or DC voltage V
4
to toggle between AC and DC modes. The AC
9
and the BLACK test lead
5
-or-
5
, and rotate the Function selector
setting. The meter
setting. The AC or
and the BLACK
11