Danger To Life - Futurelight DMH-75 Infinity Bedienungsanleitung

Install the safety bond by inserting the quick link in the attachment eyelet on the bottom of the base. Pull the
safety bond over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!

DANGER TO LIFE!

Screw the clamp/clamps via a M10 screw and nut onto the Omega-holder.
Insert the quick-lock fasteners of the Omega-holder into the respective holes
on the bottom of the device. Tighten the quick-lock fasteners fully clockwise.
On vertical trussing, please make sure that the Omega-holder and the
clamp are mounted perpendicularly to the truss, as shown on the
drawing to the right. Use only one clamp, centered on the Omega-
holder, when installing the device vertically.
37/54
(1) Omega-holder
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
00081673.DOC, Version 1.0