Klarstein Cleanhero 10009785 Bedienungsanleitung Seite 18

Automatic Charging:
1. Position the docking station on a hard, level surface against a wall.
(Refer to Figure 1)
2. No obstacle or hollow areas 3m away from the docking station in the
front and 0.5m on the right and left. (Refer to Figure 1)
3. The Robot cannot search the docking station for charging if the infrared
signal transmitting window of the docking station is covered.
4. Connect the output terminal of the adaptor with DC socket of the
docking station. (Refer to Figure 2)
5. Status of LED indicator:
A: During charging to the main body, the LED light will flash frequently
at every 1 second.
B: At standby status, the LED light will light from bright to dark.
Press the "ALL" button on the remote control to turn off the LED light
Assembly & Disassembly of Dust Box:
A. Hold the machine bottom with your hand, press the button on the dust box (Refer to Figure 1)
B. Extract the dust box with the backward force.(Refer to Figure 2)
Note: push the dust box inside to reinstall.
Cleaning of Dust Box
01. Move the two side clips of the dust box, open the fencing plate and pour off dust (as shown on
Figure 1);
02. Clean it with the cleaning brush (as shown on Figure 2).
Filter Replacement & Cleaning
A. Press the two side clips over the dust box to open the fencing plate, If the rubber part which attached
the fencing plate was worn out, you need to take out it for replacement. (Refer to figue 1)
Maintenance of the Cleaner
18