Klarstein Cleanhero 10009785 Bedienungsanleitung Seite 16

Tips:
Code check is required before you use the remote control, or it will fail to work.
Steps for code check: Please ensure the power of the remote control & cleaner are enough, and then
according to the following steps.
A: Turn off the cleaner;
B: Press and hold the "OK" button on the remote control;
C: Turn on the machine
D: After the cleaner toot twice or 3 times,release the "OK" button, then the code check set is
finished successfully.
Note:
If you fail to hear toot twice or 3 times,during the code check,just repeat the above process.
Functions Introduction of Remote Control:
• SPEED selection:
press "SPEED" button on the remote control, you canchoose fast or slow speed.
fast speed
• TIME (Current Time Setting)
Press "TIME" button first and then press
of the remote control switching among hour, minute & weekday (as shown on Pic 1)
Press buttons to change the parameter and set the hour,
minute&weekday respectively.
Tip:
During the setting, press button
the current setting.
• SET (pre-set cleaning):
A: Pre-set time
Press "SET" button first and then press
remote control will switch among hour, minute & weekday (as shown on Pic 2)
Press buttons to change the parameter to a idea time that
you want the machine work.
B: Pre-set weekday:
During pre-setting, when the shining happens to
„OK" button; the presently shining spot will have a "beam" shining
or extinguished; the weekday with the "beam"
the present pre-setting.
Press „ALL" button to switch between selection of all
Tip:
During the setting, press the
• FULL GO FUNCTION
1. Press the "SET" button, the screen shows a shinning spot
you can see "
indicates FULL GO function is activated, so the machine can automatically clean when has been
fully charged.
slow speed
to quit; press "TIME" button to save
button to quit; press the "SET" button to save the present setting.
"displaying with the first F flashing, press again the "SET" to stop flashing which
buttons, you can see a shining spot on the screen
buttons, the shining spot on the screen of the
press
shining is
or no selection of all
, then press the "STOP" button,
16