Herunterladen Diese Seite drucken

SLAT Classic 12V 2 A Bedienungsanleitung Seite 6

Werbung

4) Répéter la mesure après avoir débranché l'utilisation et la batterie.
La tension sur les câbles batterie doit être identique à celle de l'utilisation
5) Vérifier que chaque batterie de 12Vcc présente une tension égale voir supérieure à
11,5Vcc
6) Si toute les étapes sont validées vérifier la compatibilité de votre utilisation
Pour toutes demandes de retours il est obligatoire de contacter le SAV SLAT afin
d'obtenir un numéro RMA. Sans numéro RMA votre retour ne sera pas accepté.
The power suppy charger doesn't deliver voltage
1) Verify the main voltage on the main connector
2) Check the fuses
3) Verify the value of the tension on borders util 1or util 2
Verify that the battery voltage is adapted to the charger
4) Repeat the measure after having disconnected the use and the battery.
The tension on cables battery must be identical that of the use
5) Verify that every battery of 12Vdc presents a higher or more equal voltage in 11,5Vdc
6) If every steps are all right, verify the compatibility of your use
For all requests to returns a product it is mandatory to contact the Hot-line SLAT to obtain an
RMA number. Without RMA number, your return will not be accepted.
Mögliche Fehlerursachen, wenn das Netzgerät keine Ausgangsspannung liefert:
1) Überprüfen der Netzspannung
2) Überprüfen der Sicherung
3) Überprüfen des Ausgangspannungwertes
Stellen Sie sicher, dass die Batteriespannung mit dem Ladegerät übereinstimmt
4) Die Last und Batterie ausschalten und die Messungen wiederholen.
Batterie und Ausgangspannung sollen gleich sein
5) Die Spannung jedes Batterieblocks muss höher als 11,5Vdc sein
7) Wenn alles in Ordnung ist, überpüfen Sie, ob Sie das richtige Produkt für
den gewünschten Einsatzzweck verwenden.
Si le problème persiste contacter la Hot-line SLAT
First level check guide
if the problem persists contact the SLAT Hot-line
6

Werbung

loading