Error Meldungen / Warning Meldungen; Wartung - Weatherdock easy TRX 3 Bedienungsanleitung

14 Error Meldungen / Warning Meldungen

Code Group
001 Error AIS: TX malfunction
002 Error
AIS: Antenna VSWR exceeds
limit
003 Error AIS: RX channel 1 malfunction
004 Error AIS: RX channel 2 malfunction
005 Error AIS: RX channel 70
malfunction
007 Error AIS: UTC Sync invalid
026 Error AIS: no GPS since 30min
029 Error
AIS: no valid SOG information
030 Error
AIS: no valid COG information
050 Warning AIS: GPS: no valid fix
051 Warning AIS: High supply voltage
054 Warning
AIS: Base station has stopped
TX
055 Warning
AIS: No MMSI
072 Error
AIS: low supply voltage
073 Error AIS: low supply voltage while
sending
077 Error
AIS: Device overheated
078 Error
AIS: Baseband fail

15 Wartung

Die Geräte der easyTRX3 Serie haben keine Teile, die gewartet werden müssen. Zur Reinigung
des Gerätes verwenden Sie bitte ein feuchtes Tuch, keine Lösungsmittel- oder
Scheuerpulverhaltigen Reinigungsmittel.
Durch das Öffnen des Gerätes verliert das Gerät seine Garantie.
Weatherdock AG
www.easyais.com
Text
please check coaxial cable to your antenna
and also connectors, too much power is
reflected and that error is generated
no AIS reception on Channel A, 161.975MHz
no AIS reception on Channel B, 162.025MHz
no GPS position
no GPS position
no GPS position
no GPS position
no GPS position
supply voltage more than 31.2V in idle mode
AIS Base station stopped your AIS
Transmission within an local area, will be
activated after a while or when you leave
that area.
Due to no programmed MMSI, there is no AIS
transmission, please fill in your MMSI
supply voltage less then 9,6V in idle mode
due to thin cable or bad battery, the voltage
drops on AIS transmission
unit is getting too warm and will shut down
e.g. WiFi to reduce currend and cooling down
Meaning
Seite 75