Important Safety Precautions; Battery Status - Unitec Solar Bedienungsanleitung

138025 Bedienung_5-spr:77901 Bedienung
¹
µ
Solar panel
Main switch
Battery status (voltmeter)
Battery charge indicator
Reverse polarity indicator
USB connector
Connector for charger
12 Volt output switch
Battery status display button
µ 230 Volt output
¸ Inverter and USB switch
¹ 25 A fuse
12 Volt outputs
Compressor switch
Manometer
LED magnetic torch, removable
Compressor air hose
Cooling fan
Jump leads
27.05.2010 14:42 Uhr
¸
Seite 6
Operating instructions
• POWER MAINTENANCE SOLAR PANEL
• EMERGENCY STARTER BATTERY
• 260 PSI AIR COMPRESSOR
• 200 WATT INVERTER
• 12 VOLT POWER CONNECTORS
• USB POWER CONNECTOR
• MAGNETIC WORK LIGHT
A WARM WELCOME
This product has been designed and manufactured with great care for
trouble-free operation. Please read through this manual carefully before
you start to use your new product. It contains all the important informa-
tion needed for you to become familiar with its functions and to achieve
with it the performance that will bring you lasting pleasure in this pro-
duct. Keep this manual among your documents in case of any questions.
IMPORTANT
BEFORE USE PLEASE READ ALL THE WARNINGS, PRECAUTION
MEASURES AND INSTRUCTIONS SO THAT YOU UNDERSTAND THEM
AS WELL AS THE INFORMATION PUBLISHED BY YOUR VEHICLE
BATTERY MANUFACTURER AND THOSE OF THE MANUFACTURERS
OF OTHER DEVICES THAT ARE INTENDED FOR USE WITH THIS UNIT.
PLEASE KEEP THESE INSTRUCTIONS IN CASE OF ANY QUESTIONS.
IMPORTANT
SAFETY PRECAUTIONS:
• To safeguard you from any electrical risk, do not immerse the charger,
the adapters or the unit in water or any other liquids.
• Strict supervision is necessary if using the unit close to children.
• Use the unit only for its intended purpose.
• Recharge the battery after every use.
• Avoid contact with the eyes when handling batteries.
• If battery acid comes into contact with the skin or eyes, rinse it off
immediately with water and seek medical advice.
• Never let red and black terminal clamps come into contact with each
other or with the same metal object.
• Always first connect the red terminal clamp ( + ) to the positive battery
terminal.
• Do not connect the black terminal clamp (-) to the negative battery
terminal but to a fixed metal part of your vehicle.
• Only use the jump starting aid in a well-ventilated area.
• Monitor the pressure measurement device during use. Avoid pumping
up too hard.
• Do not use the compressor for longer than 20 minutes of continuous
operation. Let the compressor cool down after every continuous use.
• This is not a toy. KEEP OUT OF THE REACH OF CHILDREN.
• Do not charge whilst travelling!
OPERATING INSTRUCTIONS

BATTERY STATUS:

• Press the battery status button
• The battery status is displayed with the voltmeter
• 13-15 Volts: Ready for operation.
• 12 Volts: Charging required
• Below 12 Volts: Charge immediately
CHARGE THE JUMP START SYSTEM
Charging with alternating current at home
1. Fully charge the jump start system before its first use.
2. Only use mains adapters in combination with a correctly installed
mains socket.
3. Only use the chargers supplied with this device
4. Leave the On/Off safety switch on OFF during the charging process.
5. Put the alternating current charging cable into a normal wall socket
and the other end into the direct current charging input socket
6. One complete charging process takes about 34 hours.
Do not exceed a total charging time of 48 hours
and hold it down.
.
.