Patriot S 1x00 series Bedienungsanleitung Seite 29

3) For safety reasons, never use the machine
when it has worn or damaged parts. Parts
must be replaced and not repaired. Use
original spare parts. Parts that are not of
the same quality can damage the machine
and impair your safety.
4) Wear work gloves for disassembling and
reassembling the rotor.
5) If the machine is stopped for maintenance,
inspection or storage, or for replacing
accessories, disconnect the drive,
disconnect the machine from the power
supply and ensure that all moving parts are
completely stopped. Let the machine cool
down before performing an inspection,
adjusting, etc. Handle the machine
carefully and keep it clean.
Device-specific safety instructions
1) Power up the machine using a differential
switch (RCD - Residual Current Device)
with a tripping current of max. 30 mA.
2) The permanent connection of any electrical
equipment to the mains of a building must
be installed by a qualified electrician in
conformity with the regulations in force.
Incorrect wiring can cause serious injury
and even death.
3) WARNING: DANGER! Moisture and
electricity are not compatible:
– always handle and connect electric
cables in dry con ditions;
– never allow electric sockets or cables to
contact wet areas (puddles or wet
grass);
– the connections between cables and
sockets must always be watertight.
Only use extension leads with intact,
watertight and approved sockets sold
on the market.
4) The quality of the extension leads must be
no less than H05RN-F or H05VV-F, with a
minimum section of 1.5 mm2 and a
recommended maximum length of 25 m.
5) Never use the machine if the power cable
or extension lead are damaged or worn.
6) Never connect a damaged cable to a
mains socket and never touch a damaged
cable that is connected to the mains
socket. Damaged or deteriorated cables
may cause contact with energised parts.
7) Attach the extension lead to the cable
fastener, before starting the machine. Use
the cable fastener to prevent the cable
from disconnecting accidentally as
indicated in this manual. Make sure it is
connected to the socket without being
forced.
8) Keep extension cords away from the
working drum. The working drum can
cause damage to the cords and lead to
contact with live parts.
9) Never pull the machine by its power cable
or use the cable to pull the plug. Do not
expose the cable to sources of heat, or let
it come into contact with oil, solvents and
sharp objects.
Transportation and handling
1) Whenever the machine is to be handled,
lifted, transported or tilted you must:
– wear sturdy work gloves;
– grasp the machine at the points that
offer a safe grip, taking account of the
weight and its distribution.
– use an appropriate number of people
for the weight of the machine and the
characteristics of the vehicle or the
place where it must be placed or
collected.
2) During transport, fasten the machine
securely with cables or chains.
Risks caused by vibrations
CAUTION!
k of injury due to vibrations!
Ris
Vibrations may, in particular for
persons with circulation problems,
cause damage to blood vessels and/
or nerves.
If you notice any of the following
symptoms, stop working immediately
and consult a doctor. Numbness of
body parts, loss of sense of feeling,
itching, pins and needles, pain,
changes in skin colour.
The vibration values specified in the technical
data represent the main uses of the machine.
The actual existing vibrations during use may
deviate from these as a result of the following
factors:
- Incorrect use of the product;
- Unsuitable tools inserted;
- Unsuitable material;
- Insufficient maintenance.
EN
29 / 49