Safety Instructions; Maintenance - savic CASCADE Gebrauchsanleitung

en

safety instructions

• Ensure that the voltage of the adapter corresponds with
the electrical power supply of your home.
• In order to avoid electrical shocks, alWaYs unplug the
power supply before disassembling or cleaning the
fountain. Also the plug must not be connected during the
assembly of the fountain.
• never let the pump run dry. always ensure that there is
enough water in the fountain. the water level may never
be below the MIn level (see picture 12a). fill the reservoir
first with water up to the MaX level before connecting
the pump to the power supply.
• Use the pump only for the Cascade drinking fountain. This
pump is not suitable for other applications.
• Regularly check the product's performance. If you notice
any irregularities disconnect the fountain.
• Use the fountain only indoors.
• The Cascade is only suitable for cats and small dogs - do
not use the fountain for other purposes. Make sure that
the fountain can not be damaged or be chewed.
• The fountain is not suitable for use by children.
contents, see pages 18-19
• Water tank (1)
• Water tower (2)
• Top part/source (3)
• Filter cartridge with active carbon filter (4)
• Low voltage pump 12 V with electrical cord (5)
• AC/AC Adapter 220 – 240 V (6)
• Rubber for keeping the electrical cord in place (7+8)
• Water pickup tube and rubber ring (9)
4
140302 SAVIC HANDLEIDING CASCADE.indd 4
assembly, see pages 20-21
adjusting flow rate
• Disconnect the pump from the power supply.
• Lift up the Cascade's water tower and take the pump out of
the water tank.
• Adjust the flow rate with the small lever (a).
• Replace the pump and the tower and rubber and
reconnect the fountain.

Maintenance

Monitor regularly if the water level is above the MIN level
in the water tank. If not, fill the fountain immediately with
water up to the MAX level.
Clean your fountain weekly. Before dismantling the fountain,
always disconnect the plug from the power supply first.
Clean the fountain (except the pump and the filter) with
a soft sponge and mild detergent or wash them in the
dishwasher.
We advise you to replace the filter every month if 1 pet uses
the fountain. When used by 2 or more pets, we recommend
you to replace the filter more regularly in order to avoid a
possible blockage. A blocked filter will cause the pump not
to work properly or fail prematurely.
Clean the impeller if the pump appears dirty or stops
working properly. First disconnect the pump from the
power supply. Open the pump, remove the cap and take
the impeller out of the pump (B). Remove the dirt from the
impeller and clean the impeller carefully with a cotton swab.
To prevent lime scale, follow the same procedure and place
the impeller in a mixture of 50 % warm water and 50 %
vinegar. Also fill the impeller's chamber with this mixture.
After 2-3 hours, rub off the lime scale from the impeller and
chamber with a cotton swab. Rinse all the parts thoroughly
and reassemble.
28/01/14 16:05