Network Installation - Axis Panorama PTZ Installationsanleitung

AXIS Panorama PTZ

Network Installation

To install the AXIS Panorama PTZ on an Ethernet network, please follow these instructions for both
cameras, providing a separate IP address for each camera.
Note the Serial number on the underside of the unit. You need to know this to set the IP address.
Using an appropriate method for your operating system, assign your product with a unique IP
address from a computer on your network, as follows:
Windows only - Start a Command Prompt and type these commands:
Syntax:
arp -s <Camera IP address> <MAC address> <my PC IP address>
ping -t <Camera IP address>
Example:
arp -s 172.21.1.200 00-40-8c-10-00-86 172.21.1.193
ping -t 172.21.1.200
Note:
In some Unix systems, the arp command can be located in a directory that is not on the
command path; e.g: /usr/sbin/arp
You will now see
'
Request timed out ...
Network socket
RJ-45 connector
Approximately 10-15 seconds after connecting power, the message
'Reply from 172.21.1.200...' - or similar, is returned in the Command
Prompt window. Ensure that the Power Indicator is permanently lit and
that the Network Indicator flashes intermittently.
Exit Ping. The installation is now complete, and you are ready
to access the AXIS Panorama PTZ from your browser, as
described in the next section.
' messages repeatedly returned in the window.
Connect an Ethernet cable to your AXIS
Panorama PTZ and attach it to the network.
Connect the power adapter to the unit and
connect it to your main power supply.
Network Installation
Serial number same as
MAC/Ethernet number; e.g.
00408c100086 =
00-40-8c-10-00-86
UNIX only - Type this in your command line:
Syntax:
arp -s <IP address> <MAC address> temp
ping <IP address>
Example:
arp -s 172.21.1.200 00:40:8c:10:00:86 temp
ping 172.21.1.200
Network
Indicator
5
Power Supply
socket
Power
Indicator