Petsafe VT-100 Gebrauchsanweisung Seite 14

4. Check the tightness of the Receiver Collar by inserting
one finger between the collar and your dog's neck (3C). The
fit should be snug but not constricting.
5. Allow your dog to wear the Receiver Collar for several
minutes then recheck the fit. Check the fit again as your dog
becomes more comfortable with the Receiver Collar.
6. Trim the collar as follows: (3D)
a. Mark the desired length of the collar with a pen. Allow for
growth if your dog is young or grows a thick winter coat.
b. Remove the Receiver Collar from your dog and cut off
excess.
c. Before placing the Receiver Collar back onto your dog,
seal the edge of the cut collar by applying a flame
along the frayed edge.
The Receiver Collar should not be worn for more than 12 hours out of every 24-hour
period. Leaving the Receiver Collar on too long could lead to skin irritation. Please refer
to the "Important Safety Information" section for additional information.
Ridges
14
To Re-Thread the Collar
Slide Buckle
The slide buckle prevents the collar from becoming
loose around your pet's neck.
The ridges must be facing up; the collar will slip if it is not
properly threaded.
www.petsafe.net
3C
3D