Fit The Receiver Collar - Petsafe VT-100 Gebrauchsanweisung

Receiver Collar LED – Function and Response
Receiver Collar Function
Power on
Normal operation - Good battery
Training Tone
Pairing Complete
Receiver Collar Function
Power off
Normal operation - Low battery
Vibration Stimulation
STEP 3

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is important for
effective operation. The Vibration Points must have direct contact with your dog's skin
on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably (3A).
3. Place the Receiver Collar on your dog's neck close to
the ears. Centre the Vibration Points underneath your
dog's neck, touching the skin (3B). Note: It is sometimes
necessary to trim the hair around the Vibration Points to
make sure that contact is consistent.
Do not shave the pet's neck as this may increase the risk of skin irritation.
Green LED Response
Flashes once and beeps low to high
1 flash every 5 seconds
On length of button press
Flashes 5 times
Red LED Response
On for 3 seconds
3 flashes every 5 seconds
On length of button press
www.petsafe.net
3A
3B
13