Firmware Updating; Technical Specifications - dB Technologies RPS 10 Bedienungsanleitung

Shut down the equipment by taking back the power switch to "0" (off) position, disconnect the
power cord from the device.
3.3 ALARM SIGNALING
In normal operation the LEDs remain permanently on.
If a short circuit occurs on one of supplies, the related output is automatically disabled and its LED
will blink once per second.
The alarm signal is also sent to HUB 800 (if present) and displayed on the main menu.
For fault repair, contact an authorized dBTechnologies service center.
4

FIRMWARE UPDATING

To update the RPS10 firmware, it is necessary to install on a PC the "dB RouterView" software,
downloadable from website www.dbtechnologies.com from DWS 800 downloads sect.
The program is self-installing.
With RPS10 switched off, connect the PC to USB socket (13).
Start the software configuration of the DWS 800 system and turn on the RPS10.
Then follow the steps:
File Firmware Update
During the loading process of the new firmware, the LED of RPS10 panel lights on and off sliding
one after the other. When the procedure is finished the LED will remain on constantly and RPS 10
returns to normal operation.
Note. Make sure to load the correct firmware on the device. Uploading a wrong firmware may
cause device malfunctions.
5

TECHNICAL SPECIFICATIONS

Power supply
Fans output power supply
Standard output power supply
Temperature range
Dimensions
Weight
Load
10-120 Vac ,5A 50/60Hz
220-240 Vac 0,8A 50/60Hz
2Vcc 500 mA
2Vcc 750 mA
10°C / +50°C
1 rack unit
1,6 Kg
ENGLISH
6