Rear Panel - dB Technologies RPS 10 Bedienungsanleitung

ENGLISH
2.2

REAR PANEL

10) "Fan DC Out" Power output connector
Socket for the power supply of an additional fan placed on the Touring Rack system.
11) Power output connector "AS6W DC Out"
Socket for AS6W antenna splitter power supply.
12) Power output connector "Auxiliary DC Out"
Socket for auxiliary device optional power supply.
13) "USB" Connector
Mini USB connector to be used exclusively for the RPS10 firmware's update.
14) Receiver 1 Power output connector
Socket for MOVING D R receiver number 1 power supply.
15) Receiver 3 Power output connector
Socket for MOVING D R receiver number 3 power supply.
16) Receiver 5 Power output connector
Socket for MOVING D R receiver number 5 power supply.
17) "HUB 800 Data" Connector
RJ 11 connector for data communication with HUB 800.
18) "HUB 800" Power output connector
Socket for HUB 800 power supply.
19) Receiver 2 Power output connector
Socket for MOVING D R receiver number 2 power supply.
20) Receiver 4 Power output connector
Socket for MOVING D R receiver number 4 power supply.
21) Receiver 6 Power output connector
Socket for MOVING D R receiver number 6 power supply.
22) "Fan DC Out" Power output connector
Socket for the power supply of an additional fan placed on the Touring Rack system.
3 OPERATIONS
3.1 STARTUP
Connect the power cord supplied to the mains network and to VDE socket (Mains) (1) placed on
the front panel of RPS10.
Turn on the RPS 10 by the "Power" switch (3), all outputs are immediately enabled, the LED status
will light up in sequence.
3.2 SHUT DOWN
5
RPS10 – Wireless System Power Supply Unit