Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch Isio Originalbetriebsanleitung

OBJ_BUCH-904-001.book Page 23 Monday, December 22, 2008 11:20 AM
Switching Off
Release the On/Off switch 5.
Battery Charge-control Indication
The battery charge-control indicator 2 indicates
the charge condition of the battery for a few sec-
onds when the On/Off switch 5 is pressed
through halfway of fully.
LED
Continuous lighting, green
Flashing light, green
Flashing light, red
Continuous lighting, red

Working Advice

Hold the garden product away from your-
self. Stand in a secure and stable position.
For more tips on cutting please refer to
website www.bosch-pt.com.
Anti Blocking
The garden product has a patented feature
which works as follows:
If the blade stalls on a tough material, the load
of the motor is increasing. The intelligent micro-
electronics senses this overload condition and
repeatedly reverses the motor, in order to pre-
vent stalling and to cut the material through.
This audible reversing cut action continues for
up to 3 s.
After cutting through, the garden product con-
tinues in its normal mode, or in case the over-
load condition continues the blades automati-
cally stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the gar-
den product).
Cutting Hedges (shrub shear only)
Before cutting check the hedge for foreign ob-
jects e. g. wire fences.
Cut stems up to 8 mm in thickness. When cut-
ting, move steadily along the line of cut, so that
stems are fed directly into the cutter blades.
The double edge of the cutting blade enables
cutting to either direction, or with a side to side
motion.
After use replace the blade transport guard.
Bosch Power Tools
Recommended times
– Cut hedges with deciduous leaves in June
and October.
– Cut evergreen hedges in April and August.
– Cut conifer and other fast growing shrubs ap-
prox. every six weeks from May onwards.
Edging (grass shear only)
Guide the garden product along the edge of the
Capacity
lawn. Do not allow the blade to contact paved
≥35%
surfaces, stones or garden walls, since this will
15>35%
wear the blade rapidly.
5—15% For larger lawn it is advisable to use the tele-
scopic handle (available as an accessory or sup-
≤5%
plier with "grass shear and telescopic handle"
set).
After use replace the blade transport guard.

Maintenance and Service

Maintenance and Cleaning

Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
For safe and proper working, always keep
the garden product clean.
Always wear protective gloves when using,
adjusting or cleaning the garden product.
Note: To ensure long and reliable service, carry
out the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check if guards and protective devices are undam-
aged and properly mounted. Before using, carry
out possibly necessary maintenance and repairs.
If the garden product should happen to fail de-
spite the care taken in manufacture and testing,
repair should be carried out by an authorised cus-
tomer service agent for Bosch garden products.
In all correspondence and spare parts orders,
please always include the 10-digit article number
given on the type plate of the garden product.
English | 23
D
F 016 L70 578 | (22.12.08)