Mounting Steps - Lenze E84AZESM series Montageanleitung

5 Mechanical installation
Standard mounting

Mounting steps

5.1.1 Mounting steps
Proceed as follows for installation:
Data of threaded holes and screws (¶ Tab. 1)
1. Prepare threaded holes on the mounting plate.
2. Assemble threaded holes using screws and washers.
–
Use 4 screw and washer assemblies or hexagon socket screws with
washers.
–
Do not fully tighten the screws.
3. Mount the filter onto the prepared mounting plate.
–
Only tighten the screws hand−tight.
4. Mount the standard device to the filter.
–
Use 4 screw and washer assemblies or hexagon socket screws with
washers.
5. Pre−assemble additional units if required.
6. Align all units.
7. Screw all units to the mounting plate.
44
l
E84ZESx007
EDK84AZESxx DE/EN/FR/ES/IT 3.0