Contact With Liquid; General Specifications - Gigaset L410 Bedienungsanleitung

For more detailed information about disposal of your old appliance, please contact your local
council refuse centre or the original supplier of the product.
ECO DECT
Make your contribution towards protecting the environment with your Gigaset.
Reducing electricity consumption
An electricity-saving plug connector means your device uses less electricity.
Reducing radiation (dependent on base)
It is only possible to reduce radiation when your Gigaset base also supports this function. The
radiation from the Gigaset L410 is automatically reduced, depending on the distance from the
base. In addition, the Gigaset L410 supports the Eco Mode/Eco Mode+ functions on Gigaset
bases. For more information, please read the instructions for your base.
Appendix
Care
Wipe the unit with a damp cloth or an antistatic cloth. Do not use solvents or microfibre
cloths. Never use a dry cloth. This can cause static.

Contact with liquid

If the device comes into contact with liquid:
u Switch off the device and immediately remove the battery pack .
u Allow the liquid to drain from the device.
u Pat all parts dry. Place the device in a dry, warm place for at least 72 hours (not in a
microwave, oven etc.).
u Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
In rare cases, contact with chemical substances can cause changes to the telephone's exterior.
Due to the wide variety of chemical products available on the market, it was not possible to
test all substances.

General specifications

DECT-Standard
GAP-Standard
Radio frequency range
Transmission power
Repetition frequency of the
transmission pulse
Duration of the transmission pulse
!
Is supported
Is supported
1880–1900 MHz
10 mW, average power per channel
250 mW, pulse power
100 Hz
370 μs
31