Remote Control - Bpt XNVR2816 Gebrauchsanleitung

Playback with TIME SEARCH
From MENU, SEARCH, select TIME SEARCH.
On the right side of the window, select the data and channels. Click on SEARCH.
Give time to start playback of recording.
Click to launch the searched playback.
Playback with EVENT SEARCH
From MENU, SEARCH select EVENT SEARCH.
On the right side of the window, select the data and channels. Click on SEARCH.
Depending on the search you want to make, check MOTION, SENSOR or ALL.
The events will appear. Select the event by double clicking.
BACKUP
BACKUP is available via UBS.
From the BACKUP window you can set the backup starting and ending time and select the channels.
The ALL feature lets you back up everything.
The set BACKUP options can be controlled by users.
BACKUP starts by clicking on the START button.

REMOTE CONTROL

Remote control works only if the NVR is connected to the LAN/WAN or the internet.
Accessing the NVR via LAN
You can control the NVR's network settings from the INFORMATION window.
To set the network video parameters, photogram frequency, and so on) select RECORD SETUP.
Open the browser and enter the NVR's IP address and press enter.
The ActiveX component is downloaded from the browser.
⚠
If the http port is not the default one (80), enter the http port after the IP address.
You will need to provide USERNAME and PASSWORD.
Accessing the NVR via WAN
MENU, INFORMATION NETWORK
Run IP ADDRESS and port number forwarding on the ROUTER'S VIRTUAL SERVER of the virtual server. Configure the firewall to enable access to the NVR.
Open the browser, enter the IP ADDRESS or the dynamic domain name and press ENTER.
The ActiveX component is downloaded from the browser.
⚠
If the http port is not the default one (80), enter the http port after the IP address.
You will need to provide USERNAME and PASSWORD.