Aurora PVI-3.0-TL-OUTD Installationshandbuch Seite 52

APPENDIX
MODEL
INPUT PARAMETERS
Nominal DC Power [kW]
Max. Recommended DC Power [kW]
Operating Input Voltage Range [V]
Full Power MPPT input voltage range (symmetrical load) [V]
Full Power MPPT input voltage range (asymmetrical load) [V]
Absolute Max. Input Voltage [V]
Activation voltage "Vstart" [V]
No of independent MPPT trackers
Max. Input Power, each MPPT [kW]
No. of DC Inputs
Max. DC Current, each MPPT [A]
Absolute Max. input short circuit current (I
DC Connection
Max. inverter Backfeed Current to the array [A]
INPUT PROTECTION
Reverse polarity protection
Fuse rating, each input (-FS su x versions only) [A]
Thermally Protected DC side varistor
PV array Insulation Control
DC Switch (-S/-FS su x versions only)
OUTPUT PARAMETERS
Nominal AC Power [kW]
Max. AC Power [kW]
AC Grid Connection
Nominal AC Voltage [V]
AC Voltage Range [V]
Nominal AC Frequency [Hz]
AC Frequency Range [Hz]
Max. AC Line Current [A]
Maximum output fault current (a.c. A, peak and duration or RMS)
AC Connection
Nominal Power Factor and adjustable range
Inrush Current (a.c. A, peak and duration)
AC Current Distortion [THD%]
OUTPUT PROTECTION
AC side varistors
Ground fault protection (AC + DC leakage current)
ENVIRONMENTAL PARAMETERS
Cooling
Ambient Temp. Range [°C]
Opertaing Altitude [m]
Acoustical Noise [dBA]
Environmental IP Rating
Relative Humidity
Environmental pollution classi cation for external enviroment
MECHANICAL
Dimensions [H x W x D]
Overall Dimensions (with anges) [H x W x D]
Weight [kg]
Protective Class
Overvoltage Category in accordance with IEC 62109-1
(*) Limited to 8000W for Germany.
PVI-8.0-TL-OUTD
8,25
11
270-750
320-750 (@ 5,5kW) / 175-750 (@ 2,75kW) 380-750 (@ 6,5kW) / 225-750 (@ 3,8kW) 445-750 (@ 8kW) / 270-750 (@ 4,8kW)
360 nominal (adjustable within the range 250Vdc-500Vdc, independently/each input)
5,5
) [A]
SC
12 x Weidmüller / Multicontact Ø 4mm (6 male - positive input + 6 female - negative input) in
PVI-8.0/10.0/12.5-TL-OUTD and in PVI-8.0/10.0/12.5-TL-OUTD-FS version (Mating cable connector included),
8 x Weidmüller / Multicontact Ø 4mm (4 male - positive input + 4 female - negative input) in
Inverter protection only, from limited current source, for standard and -S versions, and for -FS version
8 (up to 60 °C)
8,9 (*)
13 ( 15 short circuit )
> 0.995, adj. ± 0.9 with P
adj. ± 0.8 with max. 8.9 kVA
-25 / +60
(**) Limited to 10000W for Belgium and Germany.
PVI-10.0-TL-OUTD
10,3
11,4
0,7xVstart - 850
300-750
900
2
6,5
6 (3 each MPPT, optionally fused) in PVI-8.0/10.0/12.5-TL-OUTD
and in PVI-8.0/10.0/12.5-TL-OUTD-FS version,
4 (2 each MPPT) in PVI-8.0/10.0/12.5-TL-OUTD-S version
17
22
PVI-8.0/10.0/12.5-TL-OUTD-S version (Mating cable connector included)
Conductor cross section: 4-6mm2 (AWG12-10)
Cable Ø w/insulator: 5,5-9mm (Multicontact), 5,5-7,5mm (Weidmüller)
Negligible
when max 2 strings are connected
12 (1000V)
4 ( 2 for each MPPT )
according to local standard
Integrated (Rating : 1000Vdc / 25A)
10 (up to 55 °C)
11 (**)
Three Phase (3W+PE or 4W+PE)
400
320-480 (may vary to comply with regulations in each country)
50 / 60
47-53 / 57-63 (may vary to comply with regulations in each country)
16,6 ( 19 short circuit )
<25 A rms (100ms)
Screw terminal block
Cable Gland: M40 - Cable Ø: 19-28mm
= 8.0 kW > 0.995, adj. ± 0.9 with P
ACR
adj. ± 0.8 with max. 11.5 kVA
Negligible
<2% at rated power with sine wave voltage
3, star connected to common point, plus gas arrester to ground
according to local standard
Natural cooling
-25 / +60 (out. power der. above 55 °C) -25 / +60 (out. power der. above 50 °C)
2000
< 50 @ 1mt
IP65
0-100% condensing
3
690 x 645 x 211
716 x 645 x 224
< 41
I
II (DC Input); III (AC Output)
8 - APP
PVI-12.5-TL-OUTD
12,8
14,3
360-750
8
18
12,5 (up to 50 °C)
13,8 (***)
20 ( 22 short circuit )
= 10.0 kW > 0.995, adj. ± 0.9 with P
ACR
adj. ± 0.8 with max. 13.8 kVA
(***) Limited to 12500W for Germany.
= 12.5 kW
ACR