20
FLUE ASSEMbLY - MOUNTING THE HOOD bODY
• Position the upper chimney section and fix the up-
per part to the frame using the 2 screws 12c (2,9 x
6,5) provided.
• Similarly, position the lower chimney section and
fix the lower part to the frame using the 2 screws
12c (2,9 x 6,5) provided.
Before fixing the hood canopy to the frame:
• Screw the 2 screws 12f half way into the holes
provided in the sides of the bottom of the frame.
• Remove the grease filters from the hood canopy.
• Remove any activated charcoal filters.
• Lift the hood canopy and engage the screws 12f in
the slots (A) as far as they will go.
• Working from below, fix the hood canopy to the
frame (B), using the 4 screws 12q and 4 washers
22 provided, then tighten all the screws securely.
ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole
switch ha-ving a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Mainte-
nance) being sure that the connector of the feeding
cable is correctly inserted in the socket placed on
the side of the fan.
• Open the junction box 24 and connect the lights
connectors Lux putting one of them into each box.
• Connect the control connector Cmd putting it in
one of the junction boxes 24.
• Close the junction boxes 24 using the screws pro-
vided.
• For the cycling version, fit the charcoal filter.
• Replace the grease filters.
���
���
���
��
���
�
��
���
��
���
EN
�
���
���
���