Fabric Brush; After Use - ROWENTA IS6300 Bedienungsanleitung

ACCESSORIES
Before using an accessory, check the manufacturer recommendations.
It is also recommend that you carry out a test on part of the fabric which cannot be seen.
1 • Fabric brush
The fabric brush opens the weave of the fabrics for better steam penetration.
Be sure unit is unplugged and completely cool before attaching accesories.
• Attach the fabric brush to the steam head by lining
up the bottom of the brush with the bottom of the
steam head. Gently push the top of the brush onto
the steam head until it clicks into place.
• Gently brush the area to be steamed with the grain
or nap of the fabric.
• Remove the fabric brush once unit is unplugged
and completely cool. Remove it by pressing on the
release tab on top of brush while pulling it forward.
2 • Lint pad
The lint pad is a separate accessory and cannot be attached to the steam head.You can
use the lint pad independently from the steamer.
The lint pad removes hair, lint and animal fur for a professional looking finish.
• To use the lint pad, slowly brush the clothing with the grain or nap of the fabric.
• The pad can be cleaned by brushing it in the opposite direction. We recommend cleaning the
pad on an old cloth that can be discarded.
• We recommend to use the lint pad before steaming your clothes for perfect results.
3 • Delicates steam cap
The steam cap cannot be used together with the fabric brush on the steam head.
Be sure the unit is unplugged and completely cool before attaching accessories.

AFTER USE

• After using the garment steamer, switch off the appliance by pressing the pedal once again.
The power indicator light will go off, and you can then unplug the appliance.
• Hang the steam head in an upright position on the hook when not in use.
• Unlock the Roll & Press handle from its hook on the pole (fig. 21). Keep your hand on the
The steam cap provides even distribution of steam,
filters impurities from the water and protects fabrics
from water dripping.
• Attach the steam cap to the steam head.
The steam head should be totally covered.
• Gently press the steam head with cap on the area
to be steamed.
• Remove the steam cap once the appliance is
unplugged and completely cool.
20