Team ST E series Gebrauchsanleitung Seite 10

Fax +32 2 359 95 50


Filter should be rinsed clean at least three times a year or when it becomes visibly solid.
Air Filter

Filter should be rinsed clean at least three times a year or when it becomes visibly solid.

Always operate the cleaner with filter installed, otherwise, reduced suction or motor damage
may result.

Disconnect from electrical outlet, before cleaning filter.

Pull filter supporter, than remove filter.

Rinse filter in lukewarm water.

Do not use a washing machine for rinsing filter nor use hair dryer for drying it.

Allow the filter to dry completely before replacing it.
TIPS

When cleaning stairs, we advise you to keep the unit in a vertical orientation.

The vacuum cleaner requires no other regular maintenance other than the filter cleaning and bag
replacement tasks as detailed elsewhere.

We advise that you ensure the power cord does not become tangled or knotted, as this will
impair the performance of the machine. Always ensure the unit is OFF and unplugged when de-
knotting or untangling the power cord.

If you notice a loss of suction power, it is probably due to one or a combination of the following
events:
 blocked filter: clean as described elsewhere
 full or punctured bag: replace as described elsewhere
 blockage in tubes: switch OFF before disassembling and removing the blockage

Always switch OFF before attempting to clean or unblock the unit.
Spare dustbags
In order to get new dustbags, please contact first of all the shop where you bought your vacuum
cleaner, or, the after sales service the address of which is mentionned on your guarantee card.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don‟t change the page
numbering. Keep the languages integrity.
Assembly page 10/29
10