Beper 90.309 Betriebsanleitung Seite 11

Juice Extractor Use instructions
DESCRIPTION OF THE COMPONENTS
1 - Presser
2 - Lid
3 - Centrifugal filter
4- Filter base
5- Locking tabs
6- Pulp container
7- Motor base
8- ON/OFF switch
9- Non-slip feet
10- Power cord
USE OF THE ELECTRIC HOUSEHOLD APPLIANCE FOR THE FIRST TIME
After you have removed the centrifuge from the wrapping you have to wash all the components,
except for the basis of the motor in warm and soaping water.
ATTENTION: not wash the centrifugal filter in your washing machine because it could demage the
stainless thin retina
Don't ever bath the basis of the motor in water but clean it with a damp cloth.
DISASSEMBLY AND REASSEMBLY OF THE CENTRIFUGE
Release the locking tabs by pulling the lower part upwards.
Remove the lid. Lift the centrifugal filter and the pulp container.
Remove the juice container and rinse it with running water
To reassemble the components of the centrifuge, place the power cord into its housing, then repo-
sition the pulp container on the motor base and the centrifugal filter in its housing. Ensure that this
has been completely fitted in place.
Rest the lid on the Pulp container and hook the locking tabs by pressing them slightly, as shown in
the
figure. Reinsert the juice container in its special seat.
INSTRUCTIONS FOR USE
Run the door of the opening wind-cable to the top and take the feeding cable out of its seat.
Verify that the tension of the device correspond to that of your system (see the technical data em-
bossed plate). Insert the plug of the feeding cable in the current tap. Push the switch to start the
CENTRIFUGE. Even the light lit up.
Pull out the presser. Introduce the food which has been previously cut into small pieces, deprived of
the stones and other tough and fibrous parts which cannot be centrifuged.
11