Polaroid ProPack Gebrauchsanleitung Seite 6

Before you take a picture
Set the digitaltimer (13)
Press and hold the SET button until the correct
development time (see the film instructions)
is displayed. The timer will always return to this
time after a development cycle until you reset it.
To reset thetimer to a new development time:
To reset it to a higher number than is now dis-
played, simply press the SET button untilthe new
time is displayed. To reset it to a lower number:
1. Press STARTonce (countdown begins).
2. Press START again (countdown stops in
mid-cycle).
3. Press SETonce (zero is displayed and preset
time is cancelled).
4. Press SET steadily until the new time is
displayed.
Check the Lighten/Darken control on the
camera
It should be set to normal as shown (14) except
in certain lighting (see "To take bright outdoor
daylight pictures") and in hot and cold weather
with colorfilm (see film instructions). Also, use
it to retake a picture that is too light or too dark.
Each mark represents % stop change in expo-
sure. When you are using the ProFlash, use the
Lighten/Darken switch on the flash unit instead
(see "To take pictures with the ProFlash").
Set the film selector (1 5)
When using color film or Type 665 film, set it to
80. When using black and white 3000 speed film,
set it to 3000 for daylight and f lashcube pictures,.
3000ER for ProFlash pictures at close and
medium range, and to 80 for ProFlash pictures of
distant subjects. See "Picture{aking guide" for
flash ranges.
Also, you can take black-and-white pictures
indoors by using available light from the scene
and setting the f ilm selector to 3000ER; for
details, see "To take indoor pictures without
flashl'
Setthe PhotoCopy screen switch (2V)
lf using the PhotoCopy screen, set the switch
to I to ensure proper exposure.
lf you are not using the PhotoCopy screen
be sure the switch is set to n. lf not set prgp-
erly, your pictures will be very light.
Set the distancescale (16)
Measure or estimate the distance from the
camera lens to your subject. Turn the lens ring
until the distance (in feet or meters) is opposite
the symbol (V) above the lens. Be sure your
subject is within the range shown in the "Picture-
taking guide" for your picture-taking situation.
View and frame your subject
As you look through the center of the viewfinder,
you should see a white frame. ll you do not see
all four corners of the franfe, move the camera
slightly untilyou do.
Whateveryou wantto include in rectangular
pictures (Types 108, 669, 668, 102 107C,667
and 665 film) must be placed within the full area
of this white frame (17).
For square-format pictures (Type 87 and 88
film), use only the area within the white frame that
is to the left of the two inner notches (18).