Quick Guide; Plug In Your Tft-1020; Preparing The Remote Control - LENCO TFT-1020 Bedienungsanleitung

QUICK GUIDE

Plug in your TFT-1020

You can use either an AC adapter or a rechargeable Li-ion battery as a power source for
your TFT-1020.
NOTICE！:
To ensure safety, please do not arbitrarily replace the power adapter, the
TFT-1020 only with the supplied AC adapter.
To use the AC adapter:
1. Plug one end of the power cord into the AC outlet.
2. Plug the cable attached to the AC adapter into the DC in port on the TFT-1020.

Preparing the Remote Control

Before using the remote controller, you need to insert the supplied battery in order to
enable communication between the TFT-1020 and remote controller.
To insert battery:
Turn the remote controller over.
Press in the tab and lift the battery cover up.
Insert the supplied battery into the remote controller.
Align the battery cover to the remote controller.
Press down until the cover clicks into place.
! If the remote controller does not operate properly, you may need to replace the battery. When the
remote controller is not being used for extended periods of time, remove the batteries to avoid
possible damage from battery leakage.
2
OPEN
PUSH