Selecting And Fitting Accessories; Flat Brush Head; Domed Brush Head; Conical Brush Head - Silvercrest SRBX 2200 A1 Bedienungsanleitung

♦ Slide the brush head holder
button on the extension rod
To use the appliance without the extension rod
♦ Slide the brush head holder
button
♦ To disassemble the components again, press the corresponding release
button
Selecting and fitting accessories
RISK OF ELECTRIC SHOCK
► Always disconnect the mains adapter
switch off the appliance before changing accessories.
♦ You can choose from three different brush heads.
Choose the appropriate brush head:

Flat brush head

The flat brush head
floors and walls.

Domed brush head

The domed brush head
sinks and fittings.

Conical brush head

The conical brush head
access, such as corners and joints.
♦ Slide the correct brush head
head holder
on the drive shaft
10 11
/
♦ To remove the brush head
with a little force
SRBX 2200 A1
6
5 3
on the handle locks into the latch of the brush head holder
5 7
/ and pull the brush head holder
11
is suitable for cleaning large, even surfaces, such as
10
is suitable for cleaning uneven surfaces, such as
12
is suitable for cleaning spots that are difficult to
8
until you feel it lock into place. Ensure that the two latches
9
slide into the corresponding gaps on the brush head
12
/ .
10
8
.
8
onto the extension rod
locks into the latch of the brush head holder
6
, proceed as follows:
8 3
onto the handle
8
or the extension rod
13
from the mains power socket and
10 11 12
/ / onto the drive shaft
/ 11 / 12 from the appliance, simply pull it off
6
so that the release
so that the release
6
9
of the brush
GB │ IE │ 23
8
.
8
.
off.
■