peerless-AV Paramount PA735F series Anbringung Und Zusammenbau Seite 7

For Flat Back Display
Begin with the shortest length screw, hand thread through washer and adapter bracket into display as shown
2-1
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through washer, adapter bracket and spacer in that order into display
2-2
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
ADAPTER BRACKET (B)
DISPLAY
SPACER
WASHER
SCREW
WASHER
SCREW
ADAPTER BRACKET (B)
7 of 38
ISSUED: 02-15-10 SHEET #: 095-9317-3 07-26-11