Troubleshooting - TFA CULT Bedienungsanleitung

TFA_No. 60.2518 Anleitung_01_13
CULT - Radio-controlled alarm clock
• The indication of the snooze interval is flashing and you
can adjust the snooze interval (from 1 minute to 59 min-
utes) with the ▲ or ▼ button.
• Confirm with the AL 1 button.
• Press and hold AL 2 button to adjust the second alarm
time.
• AL2 appears on the display and the hour digits are flash-
ing.
• If necessary adjust the second alarm time in the same way.
• To activate or deactivate the alarm function press the
corresponding button.
appears or disappears.
appears on the display.
• Press any alarm button to stop the alarm.
• The snooze function can be activated with the IR motion
sensor (wave hand 5 cm above of the sensor).
• Zz flashes on the display.
• For the duration of the pre-set interval function, the
alarm will be interrupted up to four times.
• If the alarm sound will not be interrupted manually, the
alarm clock will ring four minutes.
• Press mode button in normal mode to change the dis-
play between alarm time 1 or 2.
6.6 Backlight
• With the IR motion sensor (wave hand 5 cm above of the
sensor) the backlight will be activated for 5 secondes.
20
12.03.2013 10:43 Uhr
The corresponding symbol
, , + or no symbol
Seite 11
CULT - Radio-controlled alarm clock
7. Battery replacement
• Replace the batteries when battery symbol appears.
8. Care and maintenance
• Clean it with a soft damp cloth. Do not use solvents or
scouring agents.
• Remove the batteries if you do not use the product for a
lengthy period.
• Keep the instrument in a dry place.

9. Troubleshooting

Problems Solution
➜ Ensure batteries polarity are
No display
➜ Replace batteries
➜ Wait for attempted reception
No DCF reception
➜ Change location
➜ Manual time setting
➜ Replace batteries
Incorrect display
If your device fails to work despite these measures contact
the supplier from whom you purchased it.
correct
during the night
21