Troubleshooting - TFA 60.5016 Bedienungsanleitung

TFA_No. 60.5016_Anleitung 18.04.2019
Radio-controlled projection alarm clock with thermometer
8.1 Projection
• The projection of the time (DCF), indoor temperature and alarm symbol (if alarm is activated) appears
onto a wall or ceiling.
• Press the Projection HIGH/LOW/OFF button to adjust the brightness in 2 levels or to switch it off.
• Press and hold the Projection HIGH/LOW/OFF button to turn the image by 180°.
• Turn the dial and set the focus.
8.2 Backlight
• Press the ▲ or ▼ button to adjust the brightness in 2 levels or to switch it off (HIGH/LOW/OFF).
8.3. SNOOZE/LIGHT button
• To temporarily activate the bright backlight and projection, press the SNOOZE/LIGHT button (in battery oper-
ation or with adapter at the position LOW/OFF).
9. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries and pull out the plug of the socket if the device will not be used for an extended
period of time.
• Keep the device in a dry place.
30
13:06 Uhr Seite 16
Radio-controlled projection alarm clock with thermometer
9.1 Battery replacement
• Change the batteries when the device functions become weak (in battery operation).
• Open the battery compartment and insert two new AA 1.5 V batteries, polarity as illustrated.
• Close the battery compartment again.

10. Troubleshooting

Problem Solution
No display Battery operation:
➜ Ensure the batteries' polarities are correct
➜ Change the batteries
Operation with power adapter:
➜ Control the power adapter
➜ Press the SNOOZE/LIGHT button
No projection
Operation with power adapter:
➜ Activate with Projection HIGH/LOW/OFF button
➜ Press the SNOOZE/LIGHT button
No backlight
31