Philips HD 4637 Bedienungsanleitung Seite 4

English
Important
• Read these instructions carefully in conjunction with the illustrations before using the
appliance for the first time. Keep these instructions for future reference.
• Unless a specific reference is made, these instructions apply to both kettles types HD 4634
and HD 4637.
• This kettle has a safety cut-out which protects it against overheating due to operation with
insufficient water. If the kettle ever runs dry, switch it off and allow 10 minutes to cool
down, then refill with cold water. The safety cut-out will automatically reset. Subsequently
you can switch the kettle on again.
• Place the base unit of the kettle on a cool and firm, level surface.
• Never immerse the kettle or the base unit in water.
• If the kettle is tipped back too far, water will spill through the back cover. Though the kettle
will still be electrically safe, extra care must be taken if it contains hot or boiling water.
• WARNING: If the kettle is overfilled there is a risk that boiling water will be ejected from the
spout.
• Prevent children from pulling the mains cord. Do not let the cord hang over the edge of the
work surface.
• Pour away the very first water boiled. The kettle is then ready for use.
• The kettle must only be used with the base unit supplied.
• If the supply cord becomes damaged, it must only be replaced by an authorised Philips
service representative as special tools and/or parts are required.
General description
A
Lid
B
Off switch
C
On switch
D
Base unit
E
"Filterline" scale filter (type HD 4637)
F
1 Litre indicator (type HD 4637)
Cord storage
- For safety and convenience, the free length of
the mains cord can be reduced by pushing the
cord inside the base unit (see fig. 2).
- The minimum necessary length between the
base unit and the wall socket should be left
free.
- Insert the mains plug into the wall socket.
How to use the kettle
Filling
- The kettle must not be filled when placed on the
base unit. Take the kettle from the base unit.
- Fill the kettle through the spout (fig. 3a), or ...
- ... open the lid (fig. 3b) and fill through the lid
aperture (fig. 3c).
Do not forget to close the lid after filling (fig. 3d).
(fig. 1) Do not fill the kettle with less than 0.3 Iitre to
prevent the kettle from running dry while
operating.
Do not fill the kettle with more than 1.2 litre to
prevent water being ejected from the spout while
boiling.
1 Litre indicator (type HD 4637)
The indicator will turn orange when the kettle is
filled with one litre of water (or more) (fig. 4).
Switching on
- Place the kettle on the base unit (D) (fig. 5).
- Switch the kettle on (fig. 6).
Switching off
- The kettle will switch off automatically once the
water boils (fig. 7a)
- You can switch the kettle off manually at any
time (fig. 7b).
Some time after switching off, a click may be
heard. This is of no importance.
Switching on again ?
- You can switch the kettle on again after letting it
cool down for at least half a minute.
4