Safety Instructions; Cleaning And Care - REDWELL Rollingwave/Rondo 500 Bedienungsanleitung

DEaR cLiEnt
This manual includes important information for the installation of your Redwell infrared heating element. You have acquired an ecologic, economic heater
and are thereby making an effective contribution in saving the environment. The Redwell infrared heating system proves itself through simple installation,
flexibility in the assembling and freedom from maintenance. so you can enjoy long use of your infrared-heating element and to assure your safety, please read
the instructions before installation carefully. Keep this manual at hand and never pass on this infrared heating element without the manual.
The infrared heating element does not work on the principle of convection heat but is a radiant heater. Therefore, it is possible at the start-up that
cold areas (furniture, walls, ceiling and floors) need to be warmed up first. if you don't have a comfortable feeling of warmth immediately, then let the
heater run for several hours, or even several days if necessary, until a comfortable indoor climate is reached. as soon as the solid areas have warmed
up, a comfortable warmth will spread throughout the room and then you can pare down the running time of your heater to the minimum. to enjoy
the comfortable warmth to its fullest, we recommend you to install a high-quality control (thermostat) - please contact a specialised dealer or service
company.

safEtY instRuctions

1. The electric fixed connection to mains systems may only be done by an installation specialist taking into account the appropriate standards and
norms of the country concerned. an all-pole disconnection from the mains with a contact gap of at least 3 mm, has to be provided. disconnection
according to currently valid standard is required (overvoltage category 3).
2. The device has to be connected only to alternating current 230 Volt, 50 Hz.
3. The horizontal fixed ceiling assembly is required for a height of at least 3 m outside the contact area.
4. The device has to be earthed.
5. The minimum distance to the ceiling and to the sides of other objects and flammable items (eg curtains) has to be at least 65 cm.
6. wooden ceilings may possibly darken due to the infrared heating element's generation of heat, even when the minimum distances to the ceilings are
respected.
7. Do not put down objects on the unit and do not cover the infrared heating element!
ATTENTION: risk of over-heating and fire hazard!
8. The device has not to be exposed to excessive moisture. The unit is not water-proof, it has to be installed where there is no risk of water or other
liquids coming into contact with the device.
9. do not install or operate the device in areas where there are easy flammable gases or vapours.
10. Check that the voltage specified on the unit nameplate matches with the electrical supply before connecting it.
11. The device has to be switchable without voltage during operation at any time by switch or thermostat.
12. in case of possible disassembly or transport allow the device to cool down completely.
13. The device is not meant to be handled by persons (children included) with reduced physical, sensorial or mental faculties or without
experience and/or knowledge, unless they are supervised by a person responsible for their safety or receive instructions on how to use
the device. Children never see the danger, which can occur when dealing with electrical devices. so never leave children alone with
electrical devices. Keep small children out of reach.
14. do not try to repair the infrared-heating element on your own. The power cable cannot be replaced. The device has to be returned for
repairs to the manufacturer in any case.

cLEaning anD caRE

before cleaning the cooled device, switch off the electric current supply at the all-pole disconnection. to clean you should use a smooth and damp cloth and
some dish detergent. never clean the device and the power supply cables under running water, nor submerse in water. do not use harsh, abrasive or easily
inflammable detergents.
DisPosaL
device
The has to be disposed separately of general household waste at government places provided for this purpose. You can obtain detailed
information for disposal at the specialist dealer where the product was purchased.

instRuCtiOn Manual
gb -7