General Advice; Directions For Use - wehncke Jumbo Gebrauchsanweisung

General advice

GB
Never use an air compressor or compressed air. Inflate the article by means of blowing air into it
by using an appropriate bellows or a double action pump. Blow in sufficient air in order to fill up
the individual air chambers to their full extent; yet, the outer seams must still show folds. Thus you
avoid tearing of the welding seams. In case of improper use we cannot give guarantee.
Pay attention that the pool is placed on a horizontal, even and clean ground.
All inflatables are sensitive to cold and must be tempered before unfolding. Unfolding and infla-
ting should not be done at a temperature below +15 °C.
Safety advice
Use only under the direct supervision of an adult.

Directions for use

Inflation and Deflation:
To inflate the air chambers, pull the upper plug out of the valve neck and fill the paddling pool
with air using suitable bellows or an air pump from the WEHNCKE pump range. The black dia-
phragm in the valve stops the air escaping out of the air chamber. When the air chamber is fully
inflated, push the plug back into the valve.
To deflate, pull the lower plug out of the valve neck and open the valve completely so that the air
can escape unhindered.
In order to empty the pool completely, the pool should be squeezed at the same time.
Directions for use:
Please handle the pool with care. Avoid rubbing and dragging at walls or on floors (danger of da-
mage). In case of improper use (break or tear of material) we cannot give guarantee.
Direct sunlight may cause an increase of the air pressure. In this case release some air through the
valves until the outer seam shows again some folds.
Fill the pool only until the water reaches the marking of maximum level (see marking at the inside
wall of the pool).
Repairs
Although the pool has been manufactured of a high quality material, it is still possible to cause
holes or fissures when the pool is handled improperly. For the repair of a small damage a repair set
is available on the market. For carrying out repair work proceed as follows:
1. Clean the surface around the damaged spot by means of clean water and a mild detergent. Al-
low the sport to be repaired to dry well.
2. The repair patch should cover the damaged spot by about 3 cm over its size.
3. Apply a thin layer of the adhesive agent both on the patch and on the location to be repaired.
Allow adhesive agent to air for about one minute. Then place the patch on the spot to be re-
paired.
4. Press the patch firmly on the spot and remove all air bubbles which are under the patch.
5. Inflate the pool again only after 24 hours hardening time.
6