Spare Parts; Technical Data - Peltor FL5000 series Gebrauchsanweisung

FL5030
The switch on adapter FL5030 is intended for switching the adapter on and off. The adapter is on when the switch
is in EXT mode. In INT mode, the radio works as it does when the PTT button is not connected.
To use the radio's built-in voice control (VOX):
1. Make sure that the radio is programmed for VOX. (Contact the radio's dealer if you need help.)
2. Press and hold the PTT button, then switch on the radio. Keep the button pressed until a tone from the
radio indicates that the VOX circuit is activated.
Switching off VOX:
1. Switch off the radio.
2. Switch the radio on again without pressing the PTT button.
Note: While transmitting with VOX, you should hear your own voice in the headset. The VOX function only works on
channels programmed for VOX.

SPARE PARTS

• Cord clamp
• Attachment clamp
• Screw
• Connector cord For the type designation, see the appendix/inside cover.

TECHNICAL DATA

Max. input voltage and current:
EX-approved adapter ("EEx appr." in the following model range): Max. 9V/450mA.
Non-EX-approved adapter:
Contact:
Cord length:
Material
Unit: Semiconductive polypropylene
Push-button: Polyolefin-based TPE
Cord LAL: 5-wire cord with PUR casing and PTFE-insulated wires
LAM: Screened 6-wire cord with PUR casing and PTFE insulated wires of extremely rugged
copper alloy.
LC 6-wire cord with PUR casing and PTFE-insulated wires.
LQ: 4-wire cord with PUR casing and PTFE-insulated wires.
LR: Screened 6-wire cord with PUR casing and PTFE-insulated wires.
Durability
Bend reinforcement:
Jack:
Falling weight test:
Working temperature:
Peltor AB
Box 2341, SE-331 02 VÄRNAMO, Sweden
Tel.: +46 (0)370 694 200, Fax.: +46(0)370 15130
e-mail: info@peltor.se
TKFL01
TKD5005
FE0231
Max. 14V/350mA.
See model range
See model range
Over 100,000 bends
Can be plugged in and unplugged over 100,000 times
1.5 m after -30°C for 20 hours.
Min. -30°C, max. +55°C.
3