Setting The Torque; Replacing The Fuse On The 12 V-Plug; Maintenance And Care; Service - AEG SD 340 Bedienungsanleitungen

Operation / Maintenance and care / Service / Warranty / Disposal
clockwise rotation by pressing down on the
8
lower side (symbol h = tighten / clockwise).
j
After display of the blinking symbol „>->->"
the wheel nuts are sufficiently tightened.
j
When using a spare tire, check the air pres-
sure promptly.
j
When assembling aluminium rims, the impact
wrench should be used with care. Before, set
the torque according to the specifications of
the rim manufacturer.

Setting the torque


The electronics of the impact wrench allow a
torque selection of 80 to 340 Nm. The set torque
is shown in the 3-digit display .
3
When the previously set torque is reached, the
display will show : „>>>".
3
j Press the button (G) to increase the
5
torque. The torque increases by 10 Nm with
every activation.
j
Press the button (H) to lower the torque.
4
The torque is reduced by 10 Nm with every
activation.
j
To set the torque back to 0, press the but-
tons (G) and (H) at the same time
5 4
(reset).
notice: The following displays are possible:
000 -> 080 -> 090 ...
The display is increased in steps of 10 and
goes to 340 Nm.
Replacing the fuse on the
 
12 V-plug
j
Loosen (and remove) the knurled ring
10
turning it counter clockwise.
j Remove the defective fuse and replace it
11
with a new, max. 15 A fuse.
j Tighten the knurled ring again by turning
10
it clockwise.
18 GB

Maintenance and care


The device is maintenance-free.
WarnIng! Always separate electrical
devices from the power supply, before you carry
out service etc.
j 
D isconnect the device from the 12 V-power
source.
j 
C lean the device with a dry cloth. Do not use
solvents or other aggressive detergents
under any circumstances.

Service


WarnIng! Leave the repair of the device
to qualified technical personnel to repair. Thus
the safety of the device is guaranteed and
maintained.
WarnIng!
Leave the exchange of the plug
or the connecting cable always to qualified
technical personnel. Thus the security of the
equipment is guaranteed and maintained.

Warranty


The general guarantee conditions refer to
production and material defects.
If the device is faulty, bring it to your specialist
dealer respectively back to the sales office. In
order to accelerate the warranty and repair work
on the device, you need the following:
- A copy of the receipt (delivery note, bill)
with the acquisition date.
by - Reason for the complaint or description of
the error.

Disposal


The packing consists of pollution free materials,
which can dispose of you over the local recy-
cling stations.
Do not throw electrical appliances
into the domestic waste!
In accordance with European guideline
2002 / 96 / EC for electrical and old electronic
devices and conversion to national law, used
electrical appliances must be collected separate-
ly and brought to a environmental fair recycling.
For disposal possibilities for retired electrical
appliances please inform yourself at your
community or city administration.
Illustrations may vary slightly from the product
itself. We reserve the right to administer chang-
es due to technical progress. Decoration not
included.
Disposal
GB 19