Use Instructions; Technical Data - Beper LADY B Betriebsanleitung

Woman's Epilator Use instructions

USE INSTRUCTIONS

Make sure one of the attachments A or B a is attached to the epilation head.
Switch on the rechargeable lady shaver by pushing up the switch on/off.
Rub your skin to lift short hairs.
For optimum performance hold the appliance at a right angle (90°) against your skin. Guide it in a
slow, continuous movement without pressure against the hair growth, in the direction of the switch.
As hair can grow in different directions, it may also be helpful to guide the appliance in different
directions to achieve optimum results.
CLEANING
After epilating, unplug the appliance and clean the epilation head:
If you have used one of the attachments A or B , first remove it and clean it with the brush.
To clean the tweezer element, use the cleaning brush dipped into alcohol.
Clean the tweezers with the brush from the rear side of the epilation head while turning the barrel
manually.
After cleaning, place your preferred attachment back on the epilation head.

TECHNICAL DATA

Power 3,5W
Power supply 230-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa­
tely collected.
9