Axis Q7411 Installationsanleitung Seite 8

Page 8
Unit connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE) Class 2 - max
6.49W. Using shielded cables is recommended.
Power input connector - 2-pin terminal block used for power input from the
supplied power adapter or an external power supply.
The external power supply alternatives are:
1. The Axis delivered PS-K.
2. An external 8-28 V DC limited power source with a maximum output current of
1A.
Function Pin number
GND 1
DC Power 2
microSD memory card slot - The microSD memory card can be used for local recording with
removable storage.
Video input - AXIS Q7411 supports one video source. The video input is terminated using a
coax/BNC connector. Use a 75 ohm coaxial video cable; recommended maximum length is 250
meters (800 feet).
Note:
75 Ohm video termination can be enabled/disabled for the video input via the product's web page at
Video & Audio > Video Input > Video termination. This termination is enabled on factory default. In
cases where the product is to be connected in parallel with other equipment, for optimum video
quality, it is recommended that termination be enabled for only the last device in the video signal
chain.
Audio connectors - One 3.5 mm jack for audio input, and one 3.5 mm jack for audio output. Stereo
plugs must be used.
• Audio Input: Microphone or line level inputs (mono). A selectable 3.0V microphone bias
is available.
• Audio Output: Line level audio output (mono), that can be connected to a public
address (PA) system or an active speaker with a built-in amplifier.
Description
Ground
Power input 8-28V DC
max 5.3W
3 2 1
AXIS Q7411 Installation Guide
1 2