Operation; Optional Accessories; Maintenance - Makita 9031 Bedienungsanleitung

NOTE:
The arrow on the inside of the belt and that marked
•
on the rear pulley must point in the same direction.
Fig.4
Connecting to Makita vacuum cleaner
CAUTION:
Always close the nozzle cap when the vacuum
•
cleaner is not connected to the nozzle. Never
insert your finger into the nozzle.
Cleaner sanding operations can be performed by
connecting the belt sander to Makita vacuum cleaner.
Fig.5
When connecting to Makita vacuum cleaner, an optional
hose 28 mm in inner diameter is necessary.
Fig.6
When connecting to Makita dust collector (Model 420S),
the hose of the dust collector is not necessary. You can
connect the belt sander directly to the optional hose 28.
Fig.7

OPERATION

CAUTION:
Secure the workpiece with clamps, etc. if there is
•
any possibility of it moving during the work
operations.
The tool should not already be in contact with the
•
workpiece surface when you turn the tool on or off.
Otherwise a poor sanding finish, damage to the
belt or loss of control of the tool may result.
When working with the tool, be very careful to
•
avoid any contact of the tool and belt with any part
of your body or anyone or anything near you.
Always use the side grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations. Turn the tool on and wait until it attains full
speed. Gently apply the tool to the workpiece surface
and move the tool forward and back. Press the belt only
lightly on the workpiece. Excessive pressure may
damage the belt and shorten tool life.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.8
Remove and check the carbon brushes regularly.
Replace them when they are worn down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.9
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive belts
•
Hose 28
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
5
or attachments
Only use accessory or
are