Setup; Ac Power; Mounting; Orientation - Chauvet DJ Obey 3 Bedienungsanleitung

3. S
ETUP

AC Power

This fixture runs on 12 VDC, 500 mA. Before powering on the unit, make sure the power supply
voltage to which you are connecting it is correct.
·
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
§
To eliminate wear and improve its lifespan, during periods of non-use completely
disconnect from power via breaker or by unplugging it.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture's specifications chart. A fixture's listed current rating indicates its
average current draw under normal conditions.

Mounting

Orientation

Installation

3. Setup

The Obey™ 3 may be mounted in any safe position, provided there is adequate room for
ventilation.
Please see the drawing below, which shows the back of the controller. It details the
dimensions for mounting. This will aid in placing the holes for installation.
10