Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
opERATIoN
1. Connect one end of the USB cable to the compatible USB port or use the
AC adapter to connect the charger to the power supply socket; connect
the other end to the microUSB port of the charger.
2. Charging indicators will flash once to indicate that the charger has been
properly connected and is ready to operate.
3. Insert the batteries into the slots with correct polarity (+/-) as indicated.
4. During charging, indicator above the slot with the battery inserted,
flashes green.
5. When the batteries are fully charged, green indicator is on.
6. Remove the batteries from the slots and disconnect the charger from
power supply.
CLEANING AND mAINTENANCE
•
Prior to the cleaning make sure the device is disconnected from power
supply.
•
Clean the casing of the device with a soft and dry cloth.
•
Do not use any abrasives or chemical agents to clean this device.
•
Before storing, make sure the device is disconnected from power supply
and there are no batteries in it.
SpECIfICATIoN
•
Battery type: 1,2 V; Ni-Cd, Ni-MH; AA, AAA
•
Number of channels: 2
•
Minus delta V method
•
Pulse charging
•
Protection: overheat, overload, overvoltage, low-voltage, short circuit
•
Reverse polarity, damaged batteries and non-rechargeable batteries
detection
•
Charging indicators
•
Operating temperature: 0°C – 40°C
•
Storage temperature: -20°C – 80°C
•
Operating humidity: 0 - 60%
•
Power adapter: AC Input: 5 V / 1 A
•
In set: USB cable, user's manual
DC Output: 1,48 V; 300 mA x2
EN
OWneR's Manual
Werbung
Inhaltsverzeichnis
