Grohe SENSE GUARD Bedienungsanleitung Seite 9

Instructions on power supply:
• The valve stays open in the event of
power failure.
• The plug-in power supply is only suitable
for indoor use.
• The plug-in connectors must not be
directly or indirectly sprayed with water
when cleaning.
• The voltage supply must be able to be
switched on/off separately.
Instructions on operation:
• The water to be used must comply with
the European Drinking Water Directive.
Before using with water of a different
quality or containing additives, the
manufacturer must be consulted.
• GROHE Sense Guard may only be used
as outlined in the operating instructions.
Any other usage or usage extending
beyond that described is deemed
improper use.
• GROHE Sense Guard must only be used
in good order and condition, as intended,
and with safety and hazard awareness by
adhering to the operating instructions.
• Malfunctions are to be immediately
rectified.
• No liability is assumed for damage
associated with failure to observe these
operating instructions.
• Use only original spare parts and
accessories. The use of other parts will
void the warranty and the CE marking,
and could cause injury.
Notes on software and internet
connection:
• In order to ensure operation as a fully-
functioning device, both the smartphone
used and the GROHE Sense Guard must
be connected to the internet and the
device must be successfully installed with
the GROHE ONDUS app beforehand.
Otherwise, the device is not configured
and no warning messages can be given.
• GROHE takes all necessary measures to
ensure safe and correct use. In the event
of a malicious attack by third parties,
GROHE advises to install the latest
firmware and/or disconnect the device
from the power supply grid until you
receive further information from GROHE.
You can find complete operating
instructions and other technical
information on our website:
www.grohe.com/tpi/sense-guard
Fully read the instructions prior to installation!
Intended use
GROHE Sense Guard is suitable for use in cold potable water
up to a maximum water temperature of 40 °C.
GROHE Sense Guard is only permitted to be installed in
potable water installations for detached houses and flats that
have separate water supply lines (observe EN 806).
The GROHE Sense Guard meets the requirements of
DVGW VP 638.
GROHE ONDUS app and connection to the internet
GROHE Sense Guard connected to the internet via WLAN can
be integrated and configured in the GROHE ONDUS app. This
app can be used to provide warnings and alarms in the form of
push notifications.
A WLAN router with internet access
(2.4 GHz, IEEE 802.11b/g/n) is required.
Only WLAN channels 1 – 11 can be used.
Installation of the app:
Apple: Android:
If the app or the device firmware requires updating, the
smartphone must be located in the immediate vicinity of the
GROHE Sense Guard. In this way, possible interruptions in
function can be controlled and rectified.
Applications
The GROHE Sense Guard constantly checks water
consumption, flow rate and temperature and stores collected
data on the device and in online storage (GROHE Ondus
cloud). Threshold values can be set for the different
parameters, for which warnings are sent to the user when they
are exceeded or underrun.
Through constant monitoring, leakages are detected in good
time and water damage can be reduced by using automatic
shut-off or smartphone warnings.
A 100% protection against water damage cannot be
guaranteed for system-related reasons.
GROHE Sense Guard detects everyday water consumption
and saves this as consumption data. On this basis GROHE
Sense Guard responds to unusual situations.
There are many types of possible deviations:
• Pipe burst: an excessively large amount of water flows
through the GROHE Sense Guard. The water supply is
immediately shut off and a push notification is sent to the
connected smartphone.
8