Safety Instructions - REDWELL Middlewave R400 Bedienungsanleitung

DEaR cLiEnt,
in this manual there is important information for the installation of your Redwell infrared heating element. You have acquired an ecologic,
economic heater and are thereby making an effective contribution in saving the environment.
The Redwell infrared heating system proves itself through simple installation, flexibility in the assembling and freedom from maintenance.
so you can enjoy long use of your infrared-heating element and to assure your safety, please carefully read the instructions before installation.
Keep this manual at hand and never pass on this infrared heating element without the manual.
The infrared heating element does not work on the principle of convection heat but is a radiant heater. Therefore, it is possible at the
start-up that cold areas (furniture, walls, ceiling and floors) need to be warmed up first. if you don't immediately have a comfortable
feeling of warmth, then let the heater run for several hours, or even several days if necessary, until a comfortable indoor climate has
been reached. as soon as the solid areas have warmed up, a comfortable warmth will spread throughout the room and then you can
pare down the running time of your heater to the minimum. to enjoy the comfortable warmth to its fullest, we recommend that you
install a high-quality control (thermostat) - please contact a specialised dealer or service company.

safEtY instRuctions

1. The heating element must not be installed directly below a wall socket.
2. The installation of an infrared heating element in special rooms ( rooms with shower, bathtub or swimming pool) as well as in public
places may only be done by a specialised installation company taking into account the appropriate standards and norms of the
country concerned.
3. The infrared heating element may only be connected to alternating current 230 Volt, 50 Hz.
4. The infrared heating element must not be exposed to excessive moisture.
5. do not put down objects on the infrared heating element and do not cover the infrared heating element!
attention: risk of overheating! (thermotransfer printing!)
6. The infrared heating element is equipped with a safety temperature limiting device, which turns off in case of overheating and
automatically turns on again after cooling down.
7. The plug needs to be switchable without tension at all times during operation by switch or thermostat.
8. The heating elements without switch (except for the models with frames) fulfil the safety requirements for iP 65
(water stream protected). for the application in the safety class iP 65, the mains connection has to be modified respectively
by an installation specialist (taking into account the appropriate standards and norms of the country concerned).
fixed connection by iP 65 socket or combination plug/socket in iP 65 version.
9. The minimum distance to other objects should be 50 cm away from the front, 20 cm to the sides and 10 cm upward and downward.
1 0. For the installation of an infrared heating element on a brick or stone wall, only the holding and fixing material provided for it must be
used. On other types of wall or masonry ( as e.g. Rigips, wood,..) please use suitable holding and fixing material.
1 1. in case of possible disassembly or transport allow the infrared-heating element to completely cool down.
1 2. The infrared heating element is not meant to be handled by persons (children included) with reduced physical, sensorial or mental fa
culties or without experience and/or knowledge, unless they are supervised by a person responsible for their safety or receive
instructions on how to use the device.
Children never see the danger, which can occur when dealing with electrical devices. so never leave children alone with electrical
devices. Keep out of reach of small children.
1 3. do not try to repair the infrared-heating element, the power cable cannot be replaced and must always be returned to the
manufacturer for repairs.

instRuCtiOn Manual
gb -7