Disposal Information; Troubleshooting - Pallmann UNO Original Bedienungsanleitung

5.0 Ending the work
► After completing the work, the drive plate or tool
plate must be removed. When you leave the
machine, always unplug the power plug from the
socket. Never leave the drive plate or brush on
the machine after finishing work!
6.0 Maintenance
6.1 Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
The machine must then be sent to an after-sales
Service agent. Addresses are listed in the Section
"Aftersales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Pallmann power tools.
In all correspondence and spare parts orders, please
always include the machine number specified on the
type plate of the machine.
6.2 Spare parts
Spare parts can be found on the internet at:
http://webkatalog.Pallmann-tools.com
7.0 Trouble shooting
Fault Possible cause
The machine Power interrupted
does not start Fuse defective
Cable defective
Plug defective
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | Telefon +49 931 27964-0 | Telefax +49 931 27964-50 I www.pallmann.net
The machine
does not start
Switch-on le-
ver (3) cannot
be operated

8.0 Disposal information

Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
be collected separately and disposed of in an environmen-
tally correct manner.
Subject to change without notice
9.0 Guarantee
The warranty period for new Pallmann machines shall last
for one year from the point at which the machine is trans-
ferred / delivered to the customer, insofar as statutory legal
requirements do not stipulate otherwise.
When validating warranty claims, the invoice or proof of
purchase must always be submitted.All repairs within the
Remedy
framework of the warranty agreement must be undertaken
by a service Centre that has been accredited by us.
Contact Electrici-
Customers performing their own repairs and/or improper
an for repair and
repairs regularly lead to the exclusion of warranty claims.
/or replace parts
The same also applies to incorrect operation and/or use.
Guide rod incor-
rectly mounted
The safety switch
allows the lever
(3) to be operated
only when the
handle is inclined.
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
Install guide rod
correctly
Tilt the handle of
the machine.
23