Pallmann UNO Original Bedienungsanleitung Seite 22

System carbide milling wheel disc, #020944:
for removing adhesives, PU- and epoxy-coatings and
roughening anhydrite pavements („beating" action) Due to
the aggressive action, the system milling discs should not
be used onto chip board.
Milling disc with star wheel segments, #014243
Additional to the new System-milling-disc the milling disc
with star wheel segments offers high efficiency. Producing
a high effect of dismounting and an aggressive action, this
disc is used for removing coatings and adhesive residues.
The result is a rough surface. Comes with 4 star wheel
segments.
Cleaning pad discs 400 mm, 10 mm
For initial cleaning, #013543, For cleaning and mounting
For maintenance, #013544, For coarse cleaning and
For polishing, #013545, For polishing, cleaning and
Super pad discs 400 mm, 20 mm
For initial cleaning, #013546, For cleaning strong soiling
For maintenance, #013547, For coarse cleaning and
For polishing, #013334, For polishing, cleaning and
4.0 Use
4.1 Switching on
Mount discs or brushes as described in 3.2.
► Use the large right lever (3) to move the handle to the
working position.
► The handle (5) should be at hip height of the user.
► Slightly lift the handle (5) so that the machine is level
on the ground.
► Press the release button (1) on the back of the hand
guide.
► Switch on the machine with the levers (2) on the under-
side of the handle.
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | Telefon +49 931 27964-0 | Telefax +49 931 27964-50 I www.pallmann.net
22
of gauze
removing soil
wax coating
removing soil
wax coating
After switching on the machine, the handle will move short-
ly to the right. This is completely normal.
4.2 Steering the machine
► The direction in which the machine runs is determined
by raising and lowering the hand guide.
The more the hand guide is raised or lowered, the
faster the machine runs in the corresponding direction.
► lifting the grip: machine runs to the right
► lowering the grip: machine runs to the left.
If you feel unsafe or cannot control the machine just
release lever (3). The machine will stop at once.
If you have carried out some training, you will be able
to operate the machine with one hand.
4.3 Operation with extraction.
Note: For technical reasons, the dust extractor cannot
remove the abrasive material from the floor. They
will only ever remove the flying dust. For floor cleaning
you need an industrial vacuum cleaner with special floor
nozzles.
4.4 Operation with cleaning tank
The cleaning tank is attached to two brackets on the shaft
of the guide rod.
► Place the tank on the lower holder (8) Pic D.
► Lock the tank with the upper holder (7).
► Insert tube shown in Pic G
- Guide the chain through the hole (Pic E)
- Attach the ring to the lever (Pic E)
► Screw the chain onto the lifting rod.
► Check that there is no tension on the chain.
By pulling the handle (4), the cleaning liquid onto the
cleaning brush.