Approaching The End Positions - Griesser BiLine UniTec series Original Bedienungsanleitung

Intermediate positions for
roller shutter / awning / venetian blind
Deleting Pos ▼ (intermediate position)
!
PREREQUISITE!
The transmitter is programmed.
1. Press simultaneously:
• DOWN button
• STOP button
2. Hold down this button combination for approx. 3 seconds.
The status LED lights up briefly.
Deleting Pos ▲ (ventilation/tilting position, fabric tightening)
1. Press simultaneously:
• UP button
• STOP button
2. Hold down this button combination for approx. 3 seconds.
The status LED lights up briefly.
20 | EN

Approaching the end positions

roller shutter / awning / venetian blind
!
PREREQUISITE!
The transmitter/transmitter channel is programmed.
The end positions of the drive have been set.
Approaching the lower end position (roller shutter/awning)
Press the DOWN button briefly.
The shutter/blind approaches the lower end position/the awning
moves out.
Approaching the lower end position (venetian blind)
Press the DOWN button until the status LED lights up briefly.
The blind approaches the lower end position.
If you press the DOWN button only briefly (jogging mode), the blind
moves a short distance and stops again.
Approaching the upper end position (roller shutter/awning)
Press the UP button briefly.
The shutter/blind approaches the upper end position/the awning
retracts.
Approaching the upper end position (venetian blind)
Press the UP button until the status LED lights up briefly.
The blind approaches the upper end position.
If you press the UP button only briefly (jogging mode), the blind
moves a short distance and stops again.
EN | 21