Group Control; Selection Button Auto/Manual - Griesser BiLine UniTec series Original Bedienungsanleitung

Explanation of functions
Oper-
Status dis- ating Meaning
play mode
display
orange green Transmitter functions bidirectionally,
Operating mode Automatic
orange red Transmitter functions bidirectionally,
Operating mode Manual
3 x orange green Transmitter functions bidirectionally,
/red Operating mode Automatic,
Transmitter deleted
3 x orange red Transmitter functions bidirectionally,
/red Operating mode Manual,
Transmitter deleted
The transmitting power or radio range will be reduced by the
reduction in the performance of the battery. No more functions are
executed and there is no display, if the voltage drops below 2 Volt.
12 | EN
Explanation of functions

Group control

A group is understood to mean the control of several receivers
at the same time. The selected group is controlled by a travel
command. Any number of receivers can be programmed and con-
trolled in the channel.
The BiLine UniTec can be programmed into several receivers.

Selection button Auto/Manual

An already programmed transmitter can be switched between
automatic and manual operation by using the selection button.
The current mode of the handheld transmitter channel is queried
by briefly pressing the selection button.
Pressing and holding (for approx. 1 second) the selection but-
ton switches the automatic mode off. After the transmit signal,
the operating mode display lights up red. The receivers now only
carry out manual travel commands and do not respond to auto-
matic travel commands.
Pressing and holding (for approx. 1 second) the selection button
again, switches the automatic mode back on. After the transmit
signal, the operating mode display lights up green. The receivers
now execute automatic and manual travel commands.
EN | 13