Safety Instructions For Radio Operation; Mounting Of The Wall Bracket - Griesser BiLine UniTec series Original Bedienungsanleitung

Instructions for radio operation

Safety instructions for radio operation

CAUTION!
Observe the following safety instructions for radio
operation!
Only use radio systems, if they are allowed and can
be operated without interference.
• Please note that radio systems must not be oper-
ated in areas with an increased risk of interference
(e. g. hospitals, airports, ...).
• The remote control is permitted only for devices and
equipment for which a malfunction of the transmitter
or receiver does not give rise to a hazard to persons,
animals or objects or where this safety risk is covered
by other safety equipment.
• The operator has no protection whatsoever against
interference by other telecommunication installations
and local terminals (e. g. also from radio installations
which are operated properly in the same frequency
range).
• The range of the radio signal is limited by the govern-
ment and the built environment.
8 | EN

Mounting of the wall bracket

Mounting of the wall bracket
NOTE!
Before installation in the required assembly position,
check that the transmitter and receiver are function-
ing properly.
The bracket has to be fixed so that the drill hole does
not touch any electrical lines.
elero
Haltefeder für UniTec-868
BiLine UniTec
(Feller-Edizio)
Haltefeder zur Gerätemontage
in Feller-Edizio Mehrfachrahmen
309603.00 Nr. 18 100.9401/0406
Attach the retaining spring with
the two wall plugs and screws
which are provided to the
adaptor framework.
Slide the BiLine UniTec from
the top onto the retaining
spring.
BiLine UniTec F
(ProLine)
Attach the bracket to the wall,
with the two wall plugs and
screws which are provided.
Slide the BiLine UniTec F from
the top onto the wall bracket.
EN | 9