Venetian Blinds; Programming The Ventilation/Tilting Position - Griesser BiLine UniTec series Original Bedienungsanleitung

Intermediate positions for
roller shutter / awning / venetian blind
Roller shutter
Pos ▼
Intermediate position
Pos ▲
Ventilation position
Programming Pos ▼ (intermediate position)
!
PREREQUISITE!
The transmitter is programmed.
The end positions of the drive have been set.
The shutter/blind is in its upper end position.
1. Travel the shutter/blind to the desired position with the DOWN
button.
Keep the DOWN button pressed until the desired position has
been reached.
2. Press the STOP button in addition.
The shutter/blind stops.
The intermediate position is now programmed.
Programming Pos ▲ (ventilation/tilting position, fabric tightening)
!
PREREQUISITE!
The transmitter is programmed.
The end positions of the drive have been set.
The blind is at its lower end position.
1. Travel the shutter/blind with the transmitter as far as necessary
in the UP direction until the ventilation slots open or the tilting is
reached.
Hold down the UP button until the desired position is reached..
18 | EN
Awning Venetian blind
Intermediate position Intermediate position
Fabric tightening Tilting position
Intermediate positions for
roller shutter / awning / venetian blind
2. Press the STOP button in addition.
The shutter/blind stops.
You have programmed the position ventilation slots/tilting/fabric
tightening.
Approaching Pos ▼ (intermediate position)
!
PREREQUISITE!
The transmitter is programmed.
The intermediate position is programmed.
1. Press the DOWN button briefly twice successively.
2. The drive travels to the stored intermediate position.
If no intermediate position has been programmed, the shutter/
blind travels to the lower end position.
Approaching Pos ▲ (ventilation position/fabric tightening)
!
PREREQUISITE!
The transmitter is programmed.
The ventilation position/fabric tightening is programmed.
1. Press the UP button briefly twice successively.
2. The shutter/blind travels to the stored ventilation position/fabric
tightening.
If no ventilation/tilting position has been programmed, the shut-
ter/blind travels to the upper end position.
EN | 19